Flat Line Insulators for Steel T-posts and Polytape to 1.5"
The basic T-post insulators offered below (products 07-28, 07-29, and 07-30) hold the conductor a short distance away from the post and clip shut to hold the conductor securely. They take all polytapes up to 1.5 inches wide as well as wire and polywire.
3.5-inch Extender Insulator for Polytape to 1.5" Wide
Top’R Insulators for Round Conductors and Polytape to 1.5" Wide
Designed for T-posts, these insulators can also be nailed on top of wood posts by placing the point of the nail on the center of the insulator and driving the nail straight down and into the wood post. They will take all polytapes up to 1.5 inches wide as well as wire, polywire, and polyrope/polybraid to 3/8 inches. Top’R insulators offer important advantages to fence-builders–not only by protecting animals from the sharp and ragged tops of T-posts but also by allowing one to string a conductor along the very top of a planned or existing fence. Available in white, black, and yellow.
Corner/End Insulator/Tensioners for T-posts and Polytape to 1.5 Inches
These insulators are for ending a run of tape or for passing the tape around a corner. They have what amount to splicing buckles on them, so that one does not need to use a separate splicing buckle in order to terminate a tape, though it may be helpful to have some tape clips (product 08-20) on hand to tidy up loose ends. Product 08-02, for all polytapes up to 1.5 inches wide, attaches directly to the T-post. Product 05-06, for half-inch polytape, can be clipped onto a pin-lock insulator (like 07-13W and 07-88) to serve as an end or corner insulator or a gate anchor.
